learn the first time overclocking PC

If you're new to learn overclocking, just start with an existing computer. Better yet, if you have a computer that is unused. Nih example, we deliberately use the system's been a while.

Computers that use the Pentium-4 3GHz processor with standard cooling. As a supporter, Asus motherboard with i875P chipset, two pieces of Kingston DDR400 512MB Memory, VGA Radeon 9600Pro, and Enlight 420 watt power supply is used.
Without ba-bi-bu again, let's jump into how to overclock the processor or computer tutorials.

1. On Asus motherboards that use AMI BIOS, the options for tweaking the performance of existing systems on the "Advanced". In the "Configure System Frequency / Voltage", select the "AI Overclock Tuner". Change the setting from "Standard" to "Manual".

2. Before you overclock the processor, you should first lower the memory frequency from 400 MHz to 266 MHz. The goal is to avoid failure if the memory overclock is not able to work on 400MHz frequency. Then, what is the relationship between the processor with the memory? In this system, any increase in frequency of 1 MHz processor, memory frequency will also increase. For that, we need to create a permanent memory on the frequencies used must be supported memory.

3. In order for AGP and PCI buses do not participate in the overclock, make sure the AGP and PCI continue to work on 66 and 33MHz frequency. When the AGP and PCI frequency increases, the computer work it would be better in terms of graphics and hard disk storage alias. However, patient well. Today we discuss first overclock for processors. Moreover, storage media and VGA overclock a big risk.

4. Since the processors have the multiplier locked (can not be raised), the performance was encouraged by raising the FSB or the CPU External Frequency. Incidentally, the Pentium-4 3GHz processor that PCplus use the standard 200MHz (800MHz FSB quad pump). Try to raise that number upwards of 10 MHz (see box "Tips" to determine the magnitude of this figure.) After that, save the BIOS options and then restart the computer.

5. Pasa during POST (Power On Self Test) that baseball emerged shortly after the computer starts, you will see the processor speed has increased. In the picture it appears that the CPU External Frequency was increased from 200 to 210MHz. With multiplier (multiplier) X15 processor, the processor now has a speed of 3000MHz 3160MHz (rounded up). Let the computer continue his duties until the entry into the operating system. After that, run the software that you normally use for work. If the computer is still able to run all perfectly, return to BIOS and raise again the CPU External Frequency. Give extra again about 5 MHz to 10 MHz. Repeat this step until you have your PC becomes unstable. If the PC has been no sign of "silly", return the rule to the BIOS settings when the PC is still smooth performance. If you're still curious, please re-raise the CPU External Frequency, but now the figure is 1 to 3 MHz only.

6. We can increase the processor speed from 3000MHz to 3300MHz and 3375MHz. We do not overclock further because there are signs that the system is unstable. For example, applications that we use to always have a hang test, failed to load. When it works the way, uh test results showed a decrease in performance, rather than an increase. Pokonya not comparable to overclock that has been done. In addition, the temperature of the processor in the BIOS also has shown a rather dangerous position. In the early days of processor temperature in the range of 47 degree Celsius, after this overclock the temperature reaches 55 degrees Celsius.